Light and Motion logo
Light and Motion logo

All articles

Mounting Your Vis 180Updated 2 years ago

Mounting your Vis 180

To Your Seatpost:

Find a good place on your seatpost to attach the mount and wrap one end around the seatpost.

Bring the rubber strap around the seatpost and pull it through the slot.

Pull the rubber strap tight and bring one of the holes down over the peg.

Press the red button on the side of the mount of the light and open up the pivot arm then slide the arm into the mount until it clicks into place.

 

Removing Your Vis 180 From the Mount:

While pressing the red button on the pivot arm push the light all the way in so it is flush with the mount.

While pushing the light inwards toward the seatpost pull the light straight up so it begins sliding out of the mount.

 

 

Mounting Your Vis 180 on a Backpack Strap

The Vis 180 is designed to securely fasten to any webbing up to 1" wide. Be sure that the thickness of the webbing does not interfere with the pivot lock arm. It must be fully collapsed in its lowest position to secure the light.

Push the red button on the pivot lock arm in and pull the arm out so it clicks into the first position.

Slide the mount into a strap on your backpack being sure to bring the peg on the light all the way through.

Press the red button on the pivot lock arm and press the light inwards toward the backpack. The pivot lock arm must be fully collapsed to ensure a secure attachment. 

 

 

 

 

 

Was this article helpful?
Yes
No